Hoover CH50100 Product Manual - Page 9

ON-OFF Switch 2.3 2.3 Plug cord into electrical outlet. LED lights will flash on and then off. To turn cleaner ON, push ON/OFF switch to " | " position. To turn cleaner OFF, push ON/OFF switch to "O " position. Transporting cleaner 2.4 2.4 To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward. carry handle 2.5 2.5 The cleaner can also be moved by using the carry handle (A). A Handle positions 2.6 A 2.6 The handle of your cleaner has three B positions; (A) upright for storage and when using cleaning tools; (B) operating position for general operation on carpet and floors; (C) low for reaching under C low furniture. Step on handle release lever to lower handle into each position (B & C). Carpet height adjustment For Models with manual height adjustment 2.7 A 2.7 The cleaning of carpet and rugs takes place at the nozzle. When it is necessary to raise and lower the nozzle for various carpet pile heights, turn the nozzle control knob (A) to the desired setting. ! CAUTION ! Not to be used for grooming a pet! 2.8 A 2.8 For ease in turning knob, the handle should be in the upright position (A). The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position (B). B 2.9 2.9 For maximum cleaning performance, the following carpet height settings are recommended: • Lowest setting (1): for bare floors and low pile, level loop, kitchen-type or commercial grade carpet. • Medium setting (2): For medium pile types of carpet. • Higher settings (3-4): For very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. Note: If the cleaner is difficult to push, turn the control knob to the next higher setting. 9