Hoover H3000 Manual - Page 8
To Clean Filter
UPC - 895916001179
View all Hoover H3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
How to Empty Turn cleaner off and disconnect from electrical outlet. Although not necessary for satisfactory performance, it is recommended that the recovery tank be emptied after dry vacuuming and before wet operation. Check the solution tank also. It may need to be refilled at this time. 2-16 L To remove tank, press down on release button (L) and pivot tank forward. 2-17 N M Lift up on tank lid latch (M) and remove the tank lid (N). Empty tank. 2-18 O 2-19 P Q 2-20 R Dry or loose debris will also collect on the filter screen (O) in the tank lid. Remove debris from screen. The filter screen may also be cleaned by rinsing it under running water. The tank lid contains a washable, reusable filter. Clean this filter when suction is low or reduced. To replace lid, align tab (P) on lid with hole on front of tank (Q). Snap latch over tabs (R) on back of tank. To replace tank, insert bottom of tank into cleaner and pivot top portion until it is locked in place. To Clean Filter 2-21 S 2-22 Turn cleaner OFF and disconnect from electrical outlet. Remove recovery tank and lid (Fig. 216 & 2-17). Remove filter lid (S), then remove filter. Remove loose debris from filter by either brushing or tapping the filter. The filter may also be rinsed for additional cleaning. Allow filter to air dry between uses. Replace filter lid. Press down firmly to secure the seal. 8