Hoover U5415-900 Owners Manual - Page 5

1-11 1-12 1-13 Push bolt into hole on lower front of handle. If bolt will not go through hole easily, check the following: the bracket is properly positioned the handle is pushed completely down Place nut in recessed area at back of handle. Hold nut in place while tightening bolt securely with a screwdriver. Note: Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience. 1-14 1-15 P Q O With side of rack marked TOP FRONT facing away from cleaner handle, pull cord through rack and lower rack over handle as shown. Slide rack down handle. 1-16 Continue to slide rack down until bottom of rack is below lower cord hook (O). Snap one side of rack then the other onto lower handle. 1-17 Slide rack down handle until upper hooks (P) snap into slots (Q) on handle. 1-18 Pull bag door latch forward and remove door. Set bag door aside. 1-19 U R T T S Slide large tab (R) on bottom, back of bag compartment into slot between the bracket and the lower handle. Note round opening and hooks (S) on back of bag compartment. Place opening over dirt tube (T) and align hooks with slots in handle. Push very firmly to snap both hooks into handle. Pull on bag compartment to make sure it is completely snapped to handle. Align opening (U) in paper bag with dirt tube (T) inside bag compartment. 5 Continued §