Husqvarna M-ZT 52 Operation Manual - Page 23

Cutting Height Adjuster, Seat Adjustment Lever, Hydro Release Levers

Get Husqvarna M-ZT 52 PDF manuals and user guides View all Husqvarna M-ZT 52 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

CONTROLS Cutting Height Adjuster The desired cutting height is set with the height pin. The cutting height pedal releases the deck lift to place the deck at the selected height. For transport, push the lift pedal fully forward until the deck lift latches in the transport (highest) position. 2 1. Release pedal 2. Height pin Cut height selection pedals Seat Adjustment Lever The seat can be adjusted lengthways. The lever is located under the right side of the seat (as seen by the driver in the seat). When making adjustments the lever is moved to the left. IMPORTANT INFORMATION Seat should not be adjusted while unit is in motion. Seat adjustment Hydro Release Levers The levers are located on each side of the rear of the unit below the rear engine plate. The bypass linkage is used when manual pushing or pulling the unit. See Moving Machine By Hand in the Operation section. WARNING! Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levels are handled. Right side, ZT linkage 1 8058-223 8065-125 8065-097 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
1
2
23
CONTROLS
Cutting Height Adjuster
The desired cutting height is set with the height pin.
The cutting height pedal releases the deck lift to place
the deck at the selected height.
For transport, push the lift pedal fully forward until the
deck lift latches in the transport (highest) position.
8058-223
1. Release pedal
2. Height pin
Cut height selection pedals
Seat Adjustment Lever
The seat can be adjusted lengthways. The lever is
located under the right side of the seat (as seen by the
driver in the seat). When making adjustments the lever
is moved to the left.
8065-125
Seat adjustment
IMPORTANT INFORMATION
Seat should not be adjusted while unit is in
motion.
Hydro Release Levers
The levers are located on each side of the rear of the
unit below the rear engine plate. The bypass linkage is
used when manual pushing or pulling the unit.
See
Moving Machine By Hand
in the
Operation
section.
8065-097
Right side, ZT linkage
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levels are
handled.