Husqvarna M-ZT 52 Operation Manual - Page 34

OPERATION Moving Machine By Hand WARNING! No adjustments or maintenance should be carried out unless: • the engine stopped • the ignition key removed • the parking brake activated 2 1 When pushing or pulling the mower, engage the bypass linkages with the hydro release levers. The levers are located on each side of the rear of the unit below the engine plate. Raise the deck to the highest (transport) position. Pull the bypass linkages up and out of the keyhole slots. Release the lever with the head outside the bracket and held into the bypass setting. To reengage the hydro to drive, reverse the above procedure. WARNING! Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levels are handled. 1. Release lever locked into the bypass position 2. Release lever, engaged Right side, ZT-3400 linkage 8058-091 WARNING! Use extreme caution when loading the machine into a truck or trailer using ramps. There is the possibility of serious injury or death if the machine falls off the ramps. 34