Husqvarna M-ZT 52 Operation Manual - Page 46

LUBRICATION Engine Oil Change NOTE: Change the engine oil when the engine is warm. Refer to the engine owner's manual for the correct replacement oil and filter change recommendations. 1. Park on a level surface. Apply parking brake. 2. Clean the dirt and debris from the area around the oil fill cap. 3. Remove the cap/dipstick. 4. Locate the drain hose at the left rear of the engine. Place an adequately sized container under the end of the drain hose and remove the oil drain plug. 5. Allow the oil to fully drain from the engine. 6. Replace the drain hose plug and tighten securely. 7. Fill the engine with new oil to the bottom of the fill tube threads. Check the level with the dipstick. 8. Replace the oil fill cap securely when the oil level is FULL. 9. Refer to the Service Journal for oil checking and changing intervals. WARNING! To prevent burns, the engine should be shut off and allowed to cool slightly so the engine is still warm but the surrounding surfaces and oil are not. Engine oil drain hose 8058-262 Wheel and Deck Zerks Use only good quality bearing grease. Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality. Front Wheel Mount Lubricate with a grease gun until the grease is forced out. Front Wheel Bearings Lubricate 3-4 strokes with a grease gun on each set of wheel bearings. Lubricating front wheels 8058-068 46