Husqvarna M-ZT 52 Operation Manual - Page 43
Anti-scalp Rollers, Caster Wheels, Hardware, Removal and Installation
View all Husqvarna M-ZT 52 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
MAINTENANCE Anti-scalp Rollers Anti-scalp rollers keep the deck in the proper position to help prevent scalping in most terrain conditions. Do not adjust the rollers to support the deck. Rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. IMPORTANT INFORMATION Adjust anti-scalp rollers with the mower on a flat level surface. The anti-scalp rollers can be set in three positions: • Upper position 1 to 2½" (25 to 63 mm) grass. • Middle position 2½" to 4" (63 to 102 mm) grass. • Lower position 4" to 5" (102 to 127 mm) grass. The rollers should be approximately ¼" (6.5 mm) from ground. Do not adjust the rollers to support the deck. Anti-scalp rollers IMPORTANT INFORMATION To avoid deck damage, the anti-scalp rollers must not be adjusted to support the deck. Caster Wheels Check every 200 hours. Check that wheels rotate freely. Removal and Installation Remove nut and caster bolt. Pull the wheel out of the fork. To reInstall, reverse the order. Tighten caster bolt. If wheels do not rotate freely, take the unit to the dealer for service. Hardware Check daily. Inspect the entire machine for loose or missing hardware. Caster wheel 8058-054 8058-014 43