Image Fitness 10.2 Treadmill Owners Manual - Page 7
pulse sensor
View all Image Fitness 10.2 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Plug the lower end of the Upright Wire Harness (12) into the 20" Wire Harness (45). The small latch on the Upright Wire Harness should snap onto the 20" Wire Harness (see the upper inset drawing). If the Wire Harnesses do not fit easily, turn them; do not force the Wire Harnesses together. Slide the ends of the two 6" Cable Looms (30) against the ends of the Wire Harnesses (45, 12) (see the lower inset drawing). Be careful not to damage the Wire Harnesses. 5 45 12 45 12 30 6. Press the Belt Tool (86) into the opening in the Left Rear Endcap (82). The Belt Tool is used to center the walking belt 6 (see SYMPTOM 6 on page 14). 82 86 7. Press open the Clothes Clip (14), and insert the pulse sensor wire into the Clothes Clip. Make sure that the pulse sensor wire is resting against the hinge of the Clothes Clip (see the inset drawing). The use of the pulse sensor is explained on page 8. Make sure that all parts are tightened before using the treadmill. Note: In order to protect the floor, a covering should be placed on the floor underneath the treadmill. 7 o• 00 Pulse Sensor Wire 14 14 7