InSinkErator Model C1300 Owners Manual - Page 2

Foodservice Equipment Instant Hot Water Dispenser Installation, Care & Use Manual WHAT YOU SHOULD KNOW BEFORE YOU BEGIN For your satisfaction and safety, read all instructions, cautions and warnings before installing or using this instant hot water dispenser. Make sure that all electrical wiring and connections conform to local codes. A standard 115-volt grounded electrical outlet is required for the dispenser's electrical power. The wall outlet powering the dispenser must have power supplied to it continuously. It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system. If you suspect elevated levels of chlorine in your water, or your water has a rusty appearance before the installation of this unit, it is recommended to use our water filtration system. This product contains stainless steel. The manufacturer cannot guarantee against rusty water because of the number of factors that are involved beyond the manufacturer's control. However, the sudden appearance of rusty water discharged from the hot water dispenser may indicate the need for service or replacement of this product. Moving parts inside the tank causing a rattling noise is normal. Equipment Required: n Drill n T -fitting n Dedicated control valve n Adjustable wrench n P hillips and flat blade screwdrivers n Pencil n Tape measure n Level Equipment You May Need: Anchors for drywall Hole saw Basin wrench Hole punch IN THIS PACKAGE Hex Nut Hex Tool Brass Nut / Ferrule / Tube Insert C1300 1-1/2" Extension Rubber O-Ring Semi-circular Mounting Plate Snap-Connect 3/4" Screws (2) Fitting (3 pieces) Tank Brass Nut / Ferrule / Tube Insert Semi-circular Snap-Connect H778 4" Extension Fiber Gasket Mounting Plate Wing Nut 3/4" Screws (2) Fitting (3 pieces) Tank 2 Overview of A COMPLETED setup START HERE proper installation should take ABOUT 2-4 hours 1 Preparation a Required minimum from center of hole to wall C1300 43⁄8" H778 2" Note: Hole size requirement is 11⁄4" - 11⁄2" The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch that operates your disposer. Identify locations for the dispenser faucet, tank and filter (if applicable). C heck to make sure there is proper clearance (see chart at left) for dispenser handle to be fully opened. C heck to make sure counter is 3" thick or less. M ake sure there is a grounded electrical outlet within 30" of the tank. b If you have to drill through sink or countertop, you may need to rent or purchase the appropriate tools. Turn off water supply. If using the sink sprayer hose hole, remove nut that connects sprayer hose at bottom of faucet. Using adjustable wrench, remove nut connecting sprayer washer flange in sprayer hole. Plug hose opening with either a 1/8" plug or a 1/4" cap (not supplied). Electric Shock Hazard: Using an ungrounded or improperly connected appliance can result in serious injury or death from electrical shock. This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has a grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify the plug provided with the appliance. For Technical Assistance 1-800-845-8345 3