InSinkErator Model C1300 Owners Manual - Page 3

2 Installing the faucet - C1300 a C1300 U npack dispenser components. O n a firm, flat surface, carefully straighten the copper tubing. Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. b C1300 1 E  nsure that the black O-ring is properly seated in the base of the faucet (the groove on the underside of the faucet base). Make sure to use rubber O-ring to ensure proper seal. c C1300 F  eed tubes down through the hole in the sink or countertop until the base is at rest on the sink or countertop surface. An assistant may be needed to hold the faucet in place while securing the dispenser. d 1 Semi-circular mounting plate should encircle all descending tubes and extend beyond sink hole when tight. C1300 F  rom under t2he sink, place the semi-circular mounting plate onto the threaded stud. P  lace hex nut onto the threaded stud. Ensure faucet is at desired angle. I nsert screwdriver into hole on side of hex tool (creating a "T"), and use tool to tighten nut and secure faucet. 3 4 1 2 2 Installing the faucet - H778 a H778 U npack dispenser components. O n a firm, flat surface, carefully straighten the copper tubing. 3 Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. 1 2 b2 H778 E  nsure that the fiber gasket is properly seated against the base of the faucet. Fiber Gasket Make sure to use fiber gasket to ensure proper seal. 3 c Brass Nut Ferrule Brass Insert 1 1/4" copper tube Gasket 3 Brass Nut H778Ferrule 2 F  eed tubes down the hole in the sink or countertop until the base is at rest on the sink or countertop surface. P  osition faucet at the desired angle. An assistant may be needed to hold the faucet in place while securing the dispenser. 1 d An assistant may be needed to hold the faucet in place while securing the dispenser. Do not over tighten the mounting screw during installation, it may damage the faucet. 3 2 H778 F  rom under the sink, place the semi-circular metal mounting plate onto the threaded stud. P  lace wing nut onto the threaded stud. Make sure faucet head is at the desired angle. Tighten the wing nut until snug, while ensuring the sem3 i-circular mounting plate extends beyond the sink hole. For Technical Assistance 1-800-845-8345 5