Intel DX48BT2 Product Guide - Page 46
Connecting the IDE Cable
UPC - 735858199773
View all Intel DX48BT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Intel Desktop Board DX48BT2 Product Guide Connecting the IDE Cable The IDE cable can be used to connect two IDE drives to the Desktop Board. The cable supports the ATA-66/100 transfer protocol. Figure 25 shows the correct installation of the cable. NOTES ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. For correct function of the cable: • Observe the precautions in "Before You Begin" on page 27. • Attach the cable end with the single connector (blue) to the Intel Desktop Board (Figure 25, A). • Attach the cable end with the two closely spaced connectors (gray and black) to the drives (Figure 25, B). Figure 25. Connecting the IDE Cable 46