Intel DX48BT2 Product Guide - Page 56
Setting the BIOS Configuration Jumper, - extreme
UPC - 735858199773
View all Intel DX48BT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Intel Desktop Board DX48BT2 Product Guide 1. Observe the precautions in "Before You Begin" on page 27. 2. Connect the 12 V processor core voltage power supply cable to the 2 x 4 pin connector. Use the 2 x 2 to 2 x 4 adapter if need. NOTE Do not use the included 2 x 2 to 2 x 4 adapter when using an Intel® Pentium® processor Extreme Edition or other Intel processor that is not running at its default settings. Doing so may result in damage to the Desktop Board. 3. Connect the 1 x 4 power supply cable to the 1 x 4 connector. 4. Connect the main power supply cable to the 2 x 12 pin connector. Setting the BIOS Configuration Jumper NOTE Always turn off the power and unplug the power cord from the computer before moving the jumper. Moving the jumper with the power on may result in unreliable computer operation. Figure 31 shows the location of the Desktop Board's BIOS configuration jumper block. Figure 31. Location of the BIOS Configuration Jumper Block The three-pin BIOS jumper block enables all board configurations to be done in the BIOS Setup program. Table 14 shows the jumper settings for the BIOS Setup program modes. 56