Invacare M94 Owners Manual - Page 60
Adjusting Footrest Height
View all Invacare M94 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
SECTION 9-FRONT RIGGINGS Removing 1. Push the front rigging release lever inward and rotate the footrest out. 2. Lift up on front rigging and remove from the wheelchair. 3. Repeat STEPS 1‐2 for opposite side of wheelchair. Adjusting Footrest Height Model PHWH93 NOTE: For this procedure, refer to FIGURE 9.2. 1. Remove any accessories from the footrest(s). 2. Remove the footrest from the wheelchair. Refer to Installing/ Removing Front Riggings on page 59. NOTE: Lay footrest on a flat surface to simplify section. 3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support. 4. Reposition the lower footrest to the desired height. Locknut Coved Washer Footrest Support Coved Washer Hex Bolt Lower Footrest 5. Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest support. Tighten securely. FIGURE 9.2 Adjusting Footrest Height Model PHWH93 6. Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary. 7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 59. 8. Reinstall any accessories onto the footrest(s). Model PH904A and PHAL4A NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way. NOTE: For this procedure, refer to FIGURE 9.3. 1. Loosen, but DO NOT remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. Footrest Support Lug Bolt Locknut Lower Footrest FIGURE 9.3 Adjusting Footrest Height Model PH904A and PHAL4A Pronto® M94™ 60 Part No 1122145