Invacare RPS350-2 Owners Manual - Page 10

SECTION 2-ASSEMBLY SECTION 2-ASSEMBLY Unpacking the Patient Lift Unpack the components from the shipping carton. ƽ WARNING Use only Invacare parts in the assembly of this patient lift. The base legs, the mast, boom, pump assembly and swivel bar are manufactured to specifications that assure correct alignment of all parts for safe functional operation. Assembling the Mast Assembly to the Base NOTE: The mast assembly may be removed from the base for storage or transporting. The mast assembly MUST be properly secured to the base assembly before use. NOTE: For this procedure, refer to FIGURE 2.1. 1. Put the base on the floor. NOTE: Make sure all four casters make contact with the floor. 2. Lock both rear casters. Refer to Detail "A". 3. Remove the hex bolt, washers and nut that are located in the U-shape cut-out of the base. 4. Lift the mast to an upright position. 5. Lower the mast onto the mounting bracket. 6. Check and tighten all hardware BEFORE use. DETAIL "A" Step Here to Lock Step Here to Unlock Locking Lever UNLOCKED LOCKED Washer Nut Hex Bolt Washer Mounting Bracket FIGURE 2.1 Assembling the Mast Assembly to the Base Stand Up Patient Lift 10 Part No. 1145811