JVC FS-A52 Instruction Manual - Page 15

Continued Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level while the unit is turned on. The volume level has no effect on recording. To increase the volume, press VOLUME +. To decrease the volume, press VOLUME -. (Maximum) (Minimum) The volume level meter appears on the display. • The volume level can be adjusted in 41 steps (VOL MIN, VOL 1 - VOL 39, and VOL MAX.) • When pressing and holding the button, you can change the volume level continuously. For private listening Connect the headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on the headphones. The richness and fullness of the bass sound is clearly maintained regardless of how low you set the volume- Active Hyper Bass PRO. You can select the bass effect levels while the unit is turned on. The AHB PRO can be applied only to playback sounds, and cannot be used for recording. To get the effect, press AHB PRO. The AHB PRO indicator lights on the display. • Each time you press the button, the effect changes as follows: AHB 1 AHB 2 AHB OFF (Canceled) AHB 1: Bass sound is clearly heard even in the low volume. AHB 2: Bass sound is more effective than AHB 1. AHB OFF: Cancels the AHB PRO. The AHB PRO indicator goes off from the display. To check the AHB PRO setting currently selected, press AHB PRO once while the AHB PRO indicator is lit. DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source. REMEMBER you cannot adjust the volume level while the unit is on standby mode. Turning On/Off the Key-touch Tone If you do not want the key-touch tone to beep each time you press buttons, you can deactivate it while the unit is turned on. On the remote control ONLY: Press BEEP. • Each time you press the button, the key-touch tone turns on (BEEP ON) and off (BEEP OFF) alternately: BEEP ON BEEP OFF Selecting the Sound Modes You can select one of the 4 preset sound modes while the unit is turned on. The sound modes can be applied only to playback sounds, and cannot be used for recording. On the remote control ONLY: To select the sound modes, press SOUND MODE repeatedly until the sound mode you want appears on the display. The SOUND indicator also lights on the display. • Each time you press the button, the sound mode changes as follows: ROCK POP CLASSIC FLAT (Canceled) JAZZ ROCK: Boosts low and high frequency. Good for acoustic music. POP: Good for vocal music or voice. CLASSIC: Good for classical music. JAZZ: Good for jazz music. FLAT: Cancels the sound mode. The SOUND indicator goes off from the display. To check the sound mode currently selected, press SOUND MODE once while the SOUND indicator is lit. - 12 -