JVC FS-A52 Instruction Manual - Page 34

There are three timers available-Recording Timer, Daily Timer, and Sleep Timer. You need to set the built-in clock to use these timers. When you unplug the AC power cord or if a power failure occurs The clock setting will be reset to "AM12:00." If this happen, you need to set the clock again. Setting the Clock Using Recording Timer You can set the clock whether the unit is turned on or off (on standby.) On the remote control ONLY: 1 Press CLOCK/TIMER repeatedly until "TIME ADJUST" appears on the display. The hour digit starts flashing on the display. 2 Press ¢ or 4 repeatedly to adjust the hour. • When you press and hold the button, the hour digit changes continuously. 3 Press SET to set the hour. The minute digit starts flashing on the display. Ex. When pressing SET after adjusting the hour to 10. • If you want to correct the hour again, press CANCEL. The hour digit starts flashing again. 4 Press ¢ or 4 repeatedly to adjust the minute. • When you press and hold the button, the minute digit changes continuously. 5 Press SET to finish setting the clock. The built-in clock starts. Ex. When pressing SET after adjusting the minute to 10. With Recording Timer, you can make an unattended recording. • You can set Recording Timer whether the unit is turned on or off (on standby.) • To correct a misentry any time during the setting process, press CANCEL. How Recording Timer actually works The unit automatically turns on, and starts recording on a tape when the timer-on time comes. (While Recording Timer is working, the REC indicator keeps flashing.) Then, when the timer-off time comes, the recording stops and the unit automatically turns off (on standby.) Recording Timer works only once, but the timer settings remain stored in memory unless you reset them or unplug the AC power cord. On the remote control ONLY: 1 Press CLOCK/TIMER repeatedly until "REC TIMER" appears on the display. The timer ( ) indicator lights, and the REC indicator starts flashing on the display. REC indicator Timer indicator REC Timer mode To adjust the clock again Press CLOCK/TIMER repeatedly in step 1 until "TIME ADJUST" appears on the display, then perform steps 2 to 5 above. To check the clock time by sound while the unit is turned off (on standby) Press DIMMER while the key-touch tone is set to on. The clock time will be indicated by sound. • Each time you press the button, the timer mode changes as follows: REC TIMER DAILY TIMER Canceled TIME ADJUST - 31 -