JVC GR-D775 Instructions - Page 18
VIDEO RECORDING, Basic Recording, Tape Remaining Time, Quick Review
UPC - 046838028595
View all JVC GR-D775 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 EN VIDEO RECORDING Basic Recording NOTE: Before continuing, perform the procedures listed below: ● Power (੬ pg. 13) ● Loading A Cassette (੬ pg. 16) ● Remove the lens cap. (੬ pg. 12) ● Open the LCD monitor fully. ● Select videos at 4:3 size or 16:9 (wide) size. (੬ pg. 17) VIDEO/MEMORY Zoom Lever ● When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to "Recording From The Middle Of A Tape" (੬ pg. 20). ● To record in LP (Long Play) mode, ੬ pg. 33. Tape Remaining Time Approximate tape remaining time appears on the display. "- - - min" means the camcorder is calculating the remaining time. When the remaining time reaches 2 minutes, the indication starts blinking. ● The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used. Quick Review Lock Button Recording Start/Stop Button 1 Set the VIDEO/MEMORY Switch to "VIDEO". 2 Set the Power Switch to "REC" while pressing down the Lock Button located on the switch. 3 Press START/STOP button to start recording. "REC" appears on the display while recording is in progress. To stop recording Press START/STOP again. Approximate recording time Enables to check the end of the last recording. 1) Press QUICK REVIEW during the Recording-Standby mode. 2) Tape is rewound for about several seconds and played back automatically, then pauses in the Recording-Standby mode for the next shot. ● Distortion may occur at start of playback. This is normal. ● Slide the Power Zoom lever repeatedly to change the sound setting to on/off. Tape 30 min. 60 min. 80 min. Recording mode SP LP 30 min. 45 min. 60 min. 90 min. 80 min. 120 min. NOTES: ● If the Record-Standby mode continues for 5 minutes and no operation is performed, the camcorder's power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor.