JVC GR-D775 Instructions - Page 45
Audio Dubbing, Insert Editing
UPC - 046838028595
View all JVC GR-D775 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
EDITING EN 45 Audio Dubbing Insert Editing The audio track can be customized only when recorded in the 12-BIT and SP modes. (੬ pg. 33) ● Use the provided remote control. Speaker REW INSERT START/ STOP PAUSE PLAY STOP A.DUB Stereo Microphone 1 Play back the tape to locate the point where editing will start, then press PAUSE (8). 2 While holding A. DUB ( ) on the remote control, press PAUSE (8). The "8 " indicator appears. 3 Press PLAY (3), then begin "narrating". Speak into the microphone. ● To pause dubbing, press PAUSE (8). 4 To end Audio Dubbing, press PAUSE (8), then STOP (7). To hear the dubbed sound during playback Set "NARRATION" to "ON" or "MIX" (੬ pg. 35). NOTES: ● Sound is not heard from the speaker during Audio Dubbing. ● When editing onto a tape that was recorded at 12-BIT, the old and new soundtracks are recorded separately. ● If feedback or howling occurs during TV playback, move the camcorder's microphone away from the TV, or turn down the TV's volume. You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and out points. The original audio remains unchanged. ● Use the provided remote control. NOTES: ● Before performing the following steps, make sure that "TIME CODE" for "DISPLAY" in both Recording and Playback Menus is set to "ON". (੬ pg. 34, 35) ● Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape. 1 Play back the tape, locate the Edit-Out point and press PAUSE (8). Confirm the time code at this point. (੬ pg. 20) 2 Press REW (1) until the Edit-In point is located, then press PAUSE (8). 3 Press and hold INSERT ( ) on the remote control, then press PAUSE (8). The "8 " indicator and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode. 4 Press START/STOP to begin editing. ● Confirm the insert at the time code you checked in step 1. ● To pause editing, press START/STOP. Press it again to resume editing. 5 To end Insert Editing, press START/STOP, then STOP (7) on the remote control. NOTES: ● Program AE, Effects and Shutter Effects (੬ pg. 41) can be used to spice up the scenes being edited during Insert Editing. ● During Insert Editing, the date and time information changes. ● If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas. ● During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. ADVANCED FEATURES