JVC JY-VS200U JY-VS200U User Manual -- Pages 66-95 (616KB) - Page 10

SYMPTOM 17. The Dissolve function does not work. 18. The Picture Wipe and Dissolve functions do not work. 19. The picture wipe function does not work. 20. Scene transition does not go as expected. POSSIBLE CAUSES 17. •The Sepia, Monotone or Slow Shutter mode of Program AE with special effects is activated. •"WIDE MODE" is set to "16:9SQ." or "PS-WIDE" in the Menu Screen. •The previously selected mode of Program AE with special effects was changed after the last selected scene for editing was registered. 18. •The last selected editing scene is ending. •At the end of the last selected scene for editing, the Power Switch was set to "OFF". •The power is off. 19. •The Slow Shutter mode is activated. •"WIDE MODE" is not set to "OFF". 20. •When using "Picture Wipe/ Dissolve" (੬ pg. 34), there is a delay of a fraction of a second between the previous record stop-point and the Dissolve start-point. This is normal, but this slight delay becomes especially noticeable when shooting fast-moving subject or during rapid panning. EN75 CORRECTIVE ACTION 17. •Turn off Sepia, Monotone or Slow Shutter before adding Dissolve to a scene transition (੬ pg. 34, 36). •Set "WIDE MODE" to "16:9LB" or "OFF" mode (੬ pg. 30). •Make sure you have selected the mode of Program AE with special effects you want before starting editing (੬ pg. 34, 36). 18. •Select Picture Wipe or Dissolve before beginning recording. The effects are then automatically activated (੬ pg. 34). •Do not turn off the camcorder's power after setting Edit-In and Edit-Out points, as they will all be erased (੬ pg. 34). •The camcorder automatically shuts off after 5 minutes have elapsed in the Record-Standby mode. Make sure you continue operations within 5 minutes after engaging Record- Standby mode (੬ pg. 34). 19. •Disengage the Slow Shutter mode or set "WIDE MODE" to "OFF" before preparing to use the Picture Wipe (੬ pg. 30, 34, 36). 20. ---- CONTINUED ON NEXT PAGE JY-VS200U EN 66-95 75 01.3.12, 7:31 PM