JVC JY-VS200U JY-VS200U User Manual -- Pages 66-95 (616KB) - Page 2

Program SELECT SCENES EN67 IN OUT MODE 1-- -- : -- ~ 2 ~ 3 ~ 4 ~ 5 ~ 6 ~ 7 ~ 8 ~ T I ME CODE - - : - - TOTAL 00 : 00 Random Assemble Editing Menu 4 Point the remote control at the camcorder 's remote sensor. Press PLAY (4) and then press R.A.EDIT ON/ OFF on the remote control. The Random Assemble Editing Menu appears. 5 If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE on the remote control. •Cycle through the effects by pressing repeatedly , and stop when the one you want is displayed. •You cannot use a Picture Wipe/Dissolve at the beginning of Program 1. 6 At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu. 7 At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu. Remote sensor FADE/WIPE EFFECT EDIT IN/OUT CANCEL PLAY R.A.EDIT ON/OFF 8 If using a Fade/Wipe at the end of the scene, press FADE/WIPE. •Cycle through the effects by pressing repeatedly , and stop when the one you want is displayed. •If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point. •You cannot use a Picture Wipe/Dissolve at the end of the last scene. •When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).1 9 If using Playback Special Effects, press EFFECT (੬ pg. 64). 10 Repeat steps 6 through 9 to register additional scenes. •To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point. •If you are not using Fade/Wipe or Program AE with special effects, repeat steps 6 and 7 only. NOTES: ● When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively lar ge difference between them. ● If the search time for an in-point exceeds 5 minutes, the recording deck' s Record-Standby mode will be canceled and editing will not take place. ● If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version. ● Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly. ● Turning off the camcorder 's power erases all registered Edit-In and Edit-Out points. ● If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. T o combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing. ● It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using a DV cable. JY-VS200U EN 66-95 67 01.3.12, 7:31 PM