JVC LT-42WX70 Instructions - Page 124
The following are not malfunctions., Cannot turn on the monitor., The remote control does not work.
View all JVC LT-42WX70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Troubleshooting The following are not malfunctions. ● This LCD display is built with very high precision technology; however, be aware that a few pixels may be missing or constantly lit. ● When a still image is displayed for a long time, it may remain indistinctly on the screen after the picture has changed. The remaining picture will disappear after a while. ● The following symptoms are problems only when pictures or sounds are not played back normally. ● A slight electric shock occurs when you touch the monitor. ● The top and/or rear panel of the monitor becomes hot. ● The monitor emits a cracking noise. ● The monitor emits a mechanical noise. ● If the monitor does not operate normally, perform the following to reset the monitor. ● Turn off the power switch on the rear of the monitor, and turn it on again. ● Unplug the monitor from the wall outlet, and plug it in again. Cannot turn on the monitor. ● Connect the power cord properly. (➔ page 10) ● Turn on the power switch. (➔ page 10) The remote control does not work. ● Insert the batteries in the correct direction. (➔ page 05) ● Replace the batteries with new ones. ● Aim the remote control to the remote sensor on the monitor. (➔ page 11) ● The effective range of the remote control is about seven meters (23 feet). ● Get closer to the monitor. ● Remove any obstruction between the remote control and the monitor. No picture from a connected device. ● Select the correct input on the monitor. ● Connect the external device properly. ● Turn on the external device and start playback. 38