JVC TK-C215VP12U Instructions - Page 12
Setting the Switches and the Lens (TK-C215VP4U/E), RESET/SPOT] RESET/SPOT button
UPC - 046838027482
View all JVC TK-C215VP12U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Introduction Setting the Switches and the Lens (TK-C215VP4U/E) Set the video setting switches on the camera unit before mounting it. To set the switches, use a fine-tipped screwdriver. A RESET/[SPOT] F B G B R C LL PHASE 1 2 3 4 5 6 7 8 O N2 4 WHT. BAL. D L H IRIS E LEVEL FOCUS ADJUST Function Selection Switch Settings Chart (Characters in bold indicate factory settings) OFF ON 1 AGC OFF ON 2 SELECT PHASE WHT.BAL. 3 SYNC LL INT 4 WHT.BAL. ATW MANU 5 BLC OFF ON 6 DAY/NIGHT OFF ON 7 RESERVED 8 RESET/SPOT SET TO OFF RESET SPOT A [RESET/SPOT] RESET/SPOT button When switch #8 is set to [RESET] position and this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value. ● When switch 2 [SELECT] is set to WHT.BAL., the white balance is reset to the default value. When the switch is set to PHASE, the phase is reset to the default value. ● When switch #8 is set to SPOT: When this button is pressed, white spots are corrected. For instructions on correcting white spots, see AWhite-spot correctionB (A Pg. 34). B [R/B,+/-] R/B,+/- adjustment button This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock. The function of this button is selected using the 2 [SELECT] switch. ● When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint. Press the B button to increase the blue tint and decrease the red tint. ● When adjusting the phase: Press the + or - button to adjust the phase. C Function selection switches 1. [AGC] Auto-gain control switch. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON) 2. [SELECT] WHT.BAL./PHASE setting switch. WHT.BAL. : The B [R/B,+/-] buttons are used as [R/B] adjustment buttons. PHASE : The B [R/B,+/-] buttons are used as [+/-] adjustment buttons. (Default setting: WHT.BAL.) 12