JVC TK-C215VP12U Instructions - Page 28

POSITION ZOOM/FOCUS SELECT FAR IRIS WIDE TELE NEAR L [MEMORY] LEVEL H Installation and Connection Adjusting the video image (continued) Ⅵ TK-C215VP12U/E ● 2 types of angle of view may be selected for TK-C215VP12U/E. In general, set in a way such that the home position shoots a wide range and the alarm position a narrow range. ● Use the alarm input mode selection switch to set the actions when there is an alarm input. (A Pg. 15) ⅷ Registering home position For registering the angle of view during monitoring under normal conditions. 4. 2.,3. 1. ALARM POSITION WHT.BAL. 2 R 4 B 1 2 3 4 5 6 7 8 LL PHASE RESET/[SPOT] 3. Press the [MEMORY] button for 2 seconds or longer. The [ALARM POSITION] indicator light blinks for 3 times (green) 4. Adjust the brightness. This adjustment only needs to be made when required. Use this to accommodate particular shooting conditions. To darken image : Counterclockwise (L side) To brighten image : Clockwise (H side) Note: ● For adjusting the brightness, do not conduct it within 30 seconds after pressing the [ZOOM / FOCUS] button. ● When adjusting the iris level, set the AGC switch to AOFFB. Otherwise, when the level is turned too far toward L, the AGC function activates increasing sensitivity and the picture may look uneven. Ň Home position registration is completed 1. Check that the [ALARM POSITION] indicator light is turned off. Registration of home position is enabled. Press the [POSITION SELECT] button if the [ALARM POSITION] indicator light is on. 2. Adjust the angle of view. A Adjust the field angle Move the zoom adjustment switch in the [TELE] or [WIDE] direction to adjust the field angle. B Adjust the focus Move the focus adjustment switch in the [NEAR] or [FAR] direction to adjust the focus. Note: ● When the [ZOOM / FOCUS] switch is set to either [TELE / WIDE] or [NEAR / FAR], the iris will automatically open up for about 30 seconds and focus can be easily adjusted. During this interval, the electronic shutter mode is activated and the image may flicker. However, this is not a malfunction. 28