JVC VR-N1600UA Setup Guide - Page 27

ⅷ Playing Back 1 Press the [PLAY] button ● Playback starts from the date/time indicated in [Master Time] of [Time Navigation]. ● Images are played back according to the angle of the shuttle dial (x1/20, x1/5, x1, x2, x5, x10, x20). [Master Time] area NVRViewer [Time Navigation] Section [Browse] Screen [Go To] Button ⅷ Skipping 1 Press the [SKIP] button ● The [SKIP] buttons have the following functions. S Moves to the first image in the previous sequence. Moves to the oldest image in the database of the selected camera when the button is pressed and held down.. T Moves to the first image in the next sequence. Moves to the first image in the next sequence. When pressed and held down, moves to the latest image in the database for the selected camera. Memo : ● "Sequence" indicates a certain block of images that are recorded during motion detection. ● Recorded images are stored in the database. Note : ● The [SKIP] buttons are only enabled when a camera has been selected. ● During simultaneous recording and playback, an AAfter Database EndB message may appear as playback catches up with recording during playback near the current time. ● When recording is set to be triggered by motion/event , VR-N1600U/E will not start recording unless a motion/ event occurs. During playback near the current time, however, the image that is not recorded will also be played. ⅷ Stopping 1 Press the [STOP(PB)] button ● Playback stops. ⅷ Enlarging the Display ● Pressing a number that corresponds to the selected camera enlarges the display. ● To restore display to the normal size, press the number of the camera with enlarged display. Adjusting the Playback Speed (Jog/Shuttle Playback) You can adjust the playback speed by turning the jog dial/ shuttle dial on the front panel. Ⅵ Shuttle Playback ● Rotate the shuttle dial during playback or when playback is paused to start fast forward, fast reverse or slow playback. still Ŀøöù÷ Ŀøöù÷ Ŀøöü REV Ŀø Ŀøöü FWD Ŀø Ŀù Ŀù Ŀü Ŀü Ŀø÷ Ŀø÷ Ŀù÷ Ŀù÷ Jog/Shuttle dial Shuttle dial (Outside) Jog dial (Inside) Memo : ● The playback speed that is indicated during fast forward or fast reverse playback by rotating the shuttle dial is an approximate value. The speed may differ depending on the conditions, such as the playback mode (multi-view, single view) and the recording mode (motion detection, recorded frame rate). Ⅵ Jog Playback ● Rotate the jog dial to play back frame by frame. ● Rotate the dial clockwise to play back a single frame in the forward direction, and rotate the dial counterclockwise to play back a single frame in the reverse direction. ● Release the dial to pause the playback. However, when frames are played back successively in the forward or reverse direction, playback may continue momentarily after the jog dial is released. Note : ● The jog dial is only enabled when a camera has been selected. ● When the playback speed is adjusted or when playing back at high speed during recording, the frame rate of the recording may decrease. Check the performance meter while adjusting the playback speed to ensure that the display does not turn red. 19