Kenmore 3103 Use and Care Guide - Page 9
Before Setting, Surface, Controls
View all Kenmore 3103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Before Setting Surface Controls Assembly of the Surface Burner Heads, Burner Caps and Burner Grates for Regular Burners It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. 2. Discard all packing material located under Burner Heads (if applicable). 3. To replace the Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located c.° inside Burner Heads (Figure 1). 4. Match Burner Skirts with Burner Heads and Burner Caps (see Figure 1 ). Replace the Burner Heads and Caps on cooktop (see Figure 2). Carefully align the Electrodes into slot or hole of each Burner Head (Figure 3). Note: The Figure 2 Burner Heads should sit flat on Cooktop Burner Skirts. 5. Place the removable oven vent cover over the fixed oven vent cover. 6. Unpack Burner Grates and position on the cooktop. Figure 1 Figure 3 align intoBsulornteor r Hheoaled for each REMEMBER = DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. Dual Burner Head Assembly (some models only) Make sure that the Burner Head, Burner Caps and Burner Skirt are installed properly and at the correct locations. 1. Follow the Installation Instructions before installing and using your new range. 2. Remove all packing tape from cooktop and the dual burner. 3. Discard all packing material located under all Burners (if applicable). 4. To install Burner Head, Caps & Skirt, refer to figure 1 and follow the following steps: Step 1: Align Burner Head Pin A on Burner Base Hole. Step 2: Place Burner Skirt around Head and Base. Step 3: Align the Burner Outer Cap Hole into Burner Head Pin B. Step 4: Place Inner Burner Cap centered on Burner Base. 5. Put back the grates on the cooktop. REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. Burner Inner Cap Burner Outer Cap Burner Outer Cap Hole Burner Skirt \ "\\\\\ Burner Head Pin B Burner Head Burner Base Step 4 Step 3 Step 2 // / / Burner Head PinA Step 1 Burner Base Hole Figure 4 9