Kenmore 4104 Installation Instructions - Page 3
avoid, breakage, Do NOT handle, manipulate, by the, cooktop, glass.
View all Kenmore 4104 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
To avoid breakage: Do NOT handle or manipulate the unit by the cooktop glass. The counter-top around the cut-out should be flat and leveled (see hatched area on illustration 1). Before installing the unit, measure the heights of the two (2) cabinet sides (H1-4), front and back (see illustration 1) from the floor to the top of the counter. Level the range using the four (4)leveling legs so that the height from the floor to the underside of the cooktop glass is greater than the tallest Shave Raised 1 1/2"Max. (3.8 cm Max.) Edge to Clear Space for a 311/2" (81 cm) Wide Cooktop. cabinet measurement by at least 1/16" (see illustration 2). Illustration 1 Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of the cabinet cut-out. Remove the protective channels on each side of the glass cooktop (if provided). The metal flange under each side of the cooktop MUST be placed over the cabinet countertop for proper unit support. The glass cooktop should NOT directly touch the countertop (see illustration 2) or could cause glass breakage voiding the warranty. Level the unit if needed. After the installation, MAKE SURE that the uni is supported by the leveling legs NOT by the cooktop. "To successfully install the range, the initial level height from floor to underside of cooktop glass should be at least 1/16" taller than cabinet sides as measured in step 1. Illustration 2 3