Kenmore 4104 Installation Instructions - Page 9
forgasto move
View all Kenmore 4104 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Onceregulatoirsin placeo, penthe shutoffvalvein the Moving the Appliance for gassupplyline.Waita few minutesfor gasto move throughthegasline. Leaktesting of the applianceshallbe conducted accordingto the manufacturer'sinstructions, Servicing and Cleaning Turn off the range line fuse or circuit breakers at the main power source, and turn off the manual gas shut-off valve. Make sure the range is cold. Remove the service drawer CheckforleaksA. fterconnectinthgerangetothegassupply, (warmer drawer on some models) and open the oven door. chectkhesystemforleakws itha manometeIfra. manometer Lift the range at the front and slide it out of the cut-out isnotavailablteu,rnonthegassupplayndusealiquidleak opening without creating undue strain on the flexible gas detectoartalljointsandconnectiotnoschecfkor leaks. conduit. Make sure not to pinch the flexible gas conduit at Donot usea flameto checkfor leaks fromgasconnectionsC.heckingfor leakswitha flame mayresultin afire or explosion. the back of the range when replacing the unit into the cutout opening. Replace the drawer, close the door and switch on the electrical power and gas to the range. Allopeningsinthewallor floorwherethe rangeisto be installedmustbesealed. Tighten all connections if necessary to prevent gas leakage in the cooktop or supply line. Disconnect this range and its individual shutoff valve from the gas supply piping system during any pressure testing of the system at test pressures greater than 1/2 psig (3.5 kPa or 14"(35,56 cm)water column). Isolate the range from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa or 14"(35,56 cm) water column). LP/Propane Gas Conversion This appliance can be usedwith Natural gas or LP/Propane gas. It is shipped from the factory for use with natural gas. If you wish to convert your range for use with LP/Propane gas, use the supplied fixed orifices located in a bag containing the literature marked "FOR LP/PROPANEGAS CONVERSION." Follow the instructions packaged with the orifices. The conversion must be performed by a qualified service technician in accordance with the manufacturer's instructions and all local codes and requirements. Failure to follow these instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion. Failure to make the appropriate conversion can result in personal injury and property damage. 9