Kenmore 75051 Owners Manual - Page 7

r_ INSTALL THE AIR CONDITIONER IN THE WINDOW • Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L brackets. • When the air conditioner drops into the L brackets, the air conditioner will be centered in window opening as shown in FIG. 7. • While steadying the air conditioner, carefully bring the window sash down behind the upper guide of the air conditioner, as shown in FIG. 8. CENTER LINE FIG. 7 FIG. 8 W SECURE THE GUIDE PANELS Extend the guide panels (ITEM F) to fill the window opening using 4 screws (ITEM B) to secure them, as shown in FIG. 9. f_J INSTALL THE SASH SEAL AND SASH LOCK • Cut the foam seaI (ITEM E) to the window width. Stuff the foam seal between the glass and the window to prevent air and insects from getting into the room, as shown in FIG. 9. • Fasten the remaining L bracket on either side of the window using screw (ITEM A). See FIG. 9 inset. Installing this bracket prevents window from being raised which may result in unit falling. • Remove the screws that secure the cabinet and base pan in the right side. • Attach the support bracket (ITEM H) in the inner window sill with a screw (ITEM B), as shown Fig. 10. FIG. 10 _'-]IF AIR CONDITIONER IS BLOCKED BY STORM WINDOW FRAME • if storm window presents interference, fasten a 2" wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window silI so that the unit can be installed without interference from the the storm window frame. See FIG. 11. Top of wood strip should be approximately 3/4" higher than the storm window frame to help condensation to drain properly to the outside. • Install a second wood strip (approximately 6" long by 11/2" wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. Screw the L brackets into this strip. This will raise the L bracket as shown in FiG. 11. WOOD STRIP MOUNTED ON TOP OF bNNERSILL 1" MAX 3/4" CLEARANCE 1_ iNNER SbLL WOOD STRIP WINDOW FRAME FOR L BRACKET I INSIDE OLJTER SILL !I TSIDE FIG. 11 REMOVAL FROM WINDOW Turn the air conditioner off, and disconnect the power cord. Remove the L bracket and the screws installed through the top and bottom of the guide panels, and save for reinstallation later. Close the guide panels. Keeping a firm grip on the air conditioner, raise the sash, and carefully tilt the air conditioner backward, draining any condensate water. Lift the air conditioner from the window and remove the sash seal from between the windows. L BRACKET FOAM SEAL (ITEM E) FIG. 9 • Air conditionerscoveredin this manualposean excessiveweight hazard.Two or morepeopleare neededto moveand installthe unit. To preventinjuryor strain,useproperliftingand carryingtechniqueswhenmovingunit. • Whenhandlingthe air conditioner,be carefulto avoid cutsfrom sharpmeta!fins on front and rear coils. • Make sureair conditionerdoes notfall duringremoval. -7-