Kenwood DPX-M3200BT Instruction Manual - Page 17

Bluetooth® *1 This adjustment will not affect the volume of the other sources. *2 Press and hold VOL to continuously increase the volume to 15. *3 Operations may vary according to the connected Bluetooth device. Improve the voice quality While talking on the phone... 1 Press the volume knob to enter [FUNCTION]. 2 Turn the volume knob to select an item (see the following table), then press the knob. 3 Repeat step 2 until the desired item is selected or activated. 4 Press and hold to exit. To return to the previous setting item, press . [MIC GAIN] [NR LEVEL] [ECHO CANCEL] Default: [XX] [LEVEL -10] to [LEVEL +10] ([LEVEL -4]): The sensitivity of the microphone increases as the number increases. [LEVEL -5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level until the least noise is being heard during a phone conversation. [LEVEL -5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation delay time until the least echo is being heard during a phone conversation. Make the setting for receiving a call 1 Press to enter Bluetooth mode. 2 Turn the volume knob to select an item (see the following table), then press the knob. 3 Repeat step 2 until the desired item is selected or activated. 4 Press and hold to exit. To return to the previous setting item, press . Default: [XX] [SETTINGS] [AUTO ANSWER] [1] to [30]: The unit answers incoming call automatically in the selected time (in seconds). ; [OFF]: Cancels. [BATT/SIGNAL]* [AUTO]: Shows the strength of the battery and signal on the supplementary display (page 32) when the unit detects a Bluetooth device and the Bluetooth device is connected. ; [OFF]: Cancels. * Functionality depends on the type of the phone used. Make a call You can make a call from the call history, phonebook, or dialing the number. Call by voice is also possible if your mobile phone has the feature. 1 Press to enter Bluetooth mode. "(First device name)" appears. • If two Bluetooth phones are connected, press again to switch to the other phone. "(Second device name)" appears. 2 Turn the volume knob to select an item (see the following table), then press the knob. 3 Repeat step 2 until the desired item is selected/activated or follow the instructions stated on the selected item. 4 Press and hold to exit. To return to the previous setting item, press . [CALL HISTORY] (Applicable only if the phone supports PBAP.) 1 Press the volume knob to select a name or a phone number. • "INCOMING," "OUTGOING" or "MISSED" is shown on the lower part of the display to indicate the previous call status. • Press DISP to change the display category (NUMBER or NAME). • "NO DATA" appears if there is no recorded call history or call number. 2 Press the volume knob to call. ENGLISH 17