Kenwood VR-510 User Manual - Page 36

Remote control operations 36 Registering setup codes for other components Display Display operation 1 5/∞ Display operation 2 1 Press the display operation 1 key repeatedly until " Menu" appears in the display. Video1: VCR Menu For step 1 through step @, make sure you start the next step within 8 seconds of completing the previous one. If more than 8 seconds elapses between any two steps, press the display operation keys so that the display appears. 2 Press the display operation 2 [Menu] key repeatedly until " 01.IR" appears in the display. • The setup display appears. >01.IR >02.Surround Home Enter 3 Press the 5/∞ keys to select " 01.IR ", then press the display operation 2 [Enter] key. • The input selecting display appears. >03.Video1 >04.Video2 Back Enter • At this time all inputs become available regardless of any earlier registration. 4 Press the 5/∞ keys to select the input that you want to register. • Each time you press the 5/∞ key, the input changes as follows: 01: CD/DVD 02: MD/Tape 03: Video1 04: Video2 05: Video3 06: DVD 07: TV1 08: TV2 09: Cable 10: Phono • Example: To select the source connected to the VIDEO1 jack, select "Video1". Remote Control 5 Press the display operation 2 [Enter] key. • The source selecting display appears. • When you select "Phono" in step 4, go to step 0. >05.VCR >06.Cable Back Enter 6 Press the 5/∞ keys to select the source you want to register. • Each time you press the 5/∞ key, the input changes as follows: 01: CD 02: Tape 03: MD 04: CD-R 05: VCR 06: Cable 07: Satellit 08: TV 09: LD 10: DVD 11: DSS 12: No type 13: Delete • Select "No type" when the desired source does not appear in the display. • The selected input does not appear when you select "Delete". 7 Press the display operation 2 [Enter] key. • The maker selecting display appears. >Kenwood >Admidral Back Enter 8 Press the 5/∞ keys to select the maker you want to register. • Press the 5/∞ keys until the desired maker appears in the display. When the desired maker does not appear, select "Nothing". 9 Press the display operation 2 [Enter] key. • The setup code selecting display appears. >01:0056 >02:Nothing Back Enter 0 Press the 5/∞ keys to select the setup code. ! Press the AV POWER key, and check to see that the component you want to control turns on. If the component does not react, and there is more than one setup code, enter another setup code and try again. • If the component is already on, pressing the AV POWER key will turn it off.