Kenwood VR-510 User Manual - Page 41

- - + + 5 From the remote control unit of the other source, press the key that you want to store. • The remote code is sent to the remote control unit. • "Complete" appears when finished. Complete >Extend1 • When it takes for more than 5 seconds or the remote control unit does not receive the remote control code well, "Error" appears in the display. In this case, re-operate from step 1. 6 The remote control code is stored on the key of the remote control unit. To delete the memory stored on the key Press the display operation 1 [Clr] key in step 4. "Cleared" appears in the display. The memory previously stored is cleared. To operate other components 1 Press the MUSIC, MOVIE, or TV key to select the desired input source. 2 Press the desired key. Storing on the memory You can store on the remote control unit up to 5 memories. 1 Point the infrared ray system part of the other remote control unit to the remote sensor of the remote control unit . Remote control unit of the other source. Infrared ray system part 2 Press the MUSIC, MOVIE, or TV key to select the input of the desired remote control unit. Video1: VCR Menu Selected input 3 Press the LEARN key. • The Extend selecting display appears. When the setup code is registered >Extend1 >Extend2 Home Enter • When the setup code is not registered, any messages do not appear. 4 Press the 5/∞ keys to select the location. • Extend1 - Extend5 are available. 5 Press the display operation 2 [Enter] key. • The remote control is sent for receiving the remote control code. Waiting >Extend1 Clr Exit Remote control operations 6 From the remote control unit of the other source, press the key that you want to store. 41 • The remote code is sent to the remote control unit. • "Complete" appears when finished. Complete >Extend1 Extend 1 • When it takes for more than 5 seconds or the remote control unit does not receive the remote control code well, "Error" appears in the display. In this case, start from the step 1 again. 7 The remote control code is stored on the memory (Extend1 - Extend5) of the remote control unit. To delete the stored memory Press the display operation 1 [Clr] key in step 5. "Cleared" appears in the display and the memory that is selected in step 4 is erased. To operate other components by using the stored memory 1 Press the MUSIC, MOVIE, or TV key to select desired input source. 2 Press the display operation 2 [Menu] key during "Menu" appears in the display. • The Menu display appears. 3 Press the 5/∞ keys to select the memory you want to operate. 4 Press the display operation 2 [Enter] key. Restoring the original factory settings You can restore the setup codes or memories to their original default settings. 5 2 Remote Control Insert the batteries while pressing and holding the 5 key and 2 key. • "Cleared" appears in the display, and the remote settings return to their original default settings. • To maintain the memory settings, complete the battery replacement operation approximately within 10 minutes.