KitchenAid KFRS271TSS Use and Care Guide - Page 15
If Converted to Natural Gas, Plug in Grill - accessories
UPC - 883049057569
View all KitchenAid KFRS271TSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
9. The igniter battery is not factory installed. A 1.5-volt "D" size alkaline battery is located in the accessory box on the grill grate. Install battery at this time following the instructions in the "Replacing the Igniter Battery" section. 10. Go to "Check and Adjust the Burners" section. If Converted to Natural Gas WARNING ■ Pipe-joint compounds suitable for use with Natural gas must be used. Do not use TEFLON®† tape. A B C Explosion Hazard Use a new CSA International approved "outdoor" gas supply line. Securely tighten all gas connections. Failure to do so can result in death, explosion, or fire. This installation must conform with local codes and ordinances. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or CAN/CGAB149.1 Natural Gas and Propane installation code. Copies of the standards listed above may be obtained from: CSA International 8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575 National Fire Protection Association One Batterymarch Park Quincy, Massachusetts 02269 1. Make gas connections. A combination of pipe fittings must be used to connect the grill to the existing gas line. ■ If local codes permit, use an outdoor flexible stainless steel tubing gas connector, design-certified by CSA International, to connect the grill to the rigid gas supply line. A ⁵⁄₈" diameter line is recommended. Using a wrench to tighten, connect the gas supply to the grill. Use pipejoint compound on all non-flared male threads. Do not kink or damage the flexible connector when moving the grill. D A. Grill gas pipe B. New ANSI Z21.54 certified gray hose C. Rear of grill D. To Natural gas supply 2. Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A B A. Closed valve B. Open valve 3. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found. 4. The igniter battery is not factory installed. A 1.5-volt "D" size alkaline battery is located in the accessory box on the grill grate. Install battery at this time following the instructions in the "Replacing the Igniter Battery" section. 5. Go to "Check and Adjust the Burners" section. Plug in Grill WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3-prong outlet. †®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company. 15