KitchenAid KFRS271TSS Use and Care Guide - Page 5
Installation Requirements - parts
UPC - 883049057569
View all KitchenAid KFRS271TSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
INSTALLATION REQUIREMENTS Tools and Parts Style 1 - Freestanding Outdoor Grills Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers ■ #2 and #3 Phillips screwdriver (to remove tiedowns) ■ Level ■ Noncorrosive leakdetection solution Parts Supplied ■ Gas pressure regulator/hose assembly set for 11" WCP LP gas (attached to manifold). ■ 1.5-volt "D" size alkaline battery Parts Needed ■ 20 lb LP gas fuel tank Tools and Parts Style 2 - Built-In Outdoor Grills Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers ■ #2 and #3 Phillips screwdriver (to remove tiedowns) ■ Level ■ Noncorrosive leakdetection solution Parts Needed ■ Gas line shutoff valve ■ ½" male pipe thread nipple for connection to pressure regulator. ■ LP gas-resistant pipe-joint compound ■ CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed. Parts Supplied ■ Convertible regulator set for 4" WCP Natural gas. ■ Single-prong plug/5,000 mAmp transformer assembly ■ 1.5-volt "D" size alkaline battery Location Requirements WARNING Explosion Hazard Do not store fuel tank in a garage or indoors. Do not store grill with fuel tank in a garage or indoors. Failure to follow these instructions can result in death, explosion, or fire. WARNING Fire Hazard Do not use grill near combustible materials. Do not store combustible materials near grill. Doing so can result in death or fire. Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas. Do not obstruct flow of combustion and ventilation air. Clearance to combustible construction for built-in and freestanding outdoor grills: ■ A minimum of 24" (58 cm) must be maintained between the front of the grill hood, sides and back of the grill and any combustible construction. ■ A 24" (58 cm) minimum clearance must also be maintained below the cooking surface and any combustible construction. Rotisserie (accessory)* If you equip your grill with a rotisserie, a 6" (15.2 cm) minimum clearance is needed for the rotisserie motor. A grounded, 3-prong outlet located to the left of the grill is required. See "Electrical Requirements" section. *See "Assistance or Service" section to order. 5