Konica Minolta bizhub 4750 bizhub 4750/4050 Maintenance/Troubleshooting User G - Page 31

3.3 Troubleshooting for paper jam 3 Symptom A paper jam has occurred in the paper tray. A paper jam has occurred in the Finisher. Cause Paper is not loaded in the correct position in the paper tray. The number of sheets in the paper tray exceeds the maximum capacity. The width of the paper guide has not adjusted to the paper size. Bent or creased paper has been loaded into the paper tray. Paper is damp. Postcards or envelopes are loaded into Tray 1/2/3/4. Label sheets are loaded in an incorrect orientation. Envelopes are loaded in an incorrect orientation. Invalid paper (paper of an invalid size, thickness, or type) is used. Invalid paper (paper of an invalid size, thickness, or type) is used. Action Remove the jammed paper, then correctly load paper into the paper tray. Remove excessive sheets in the paper tray, then re-load paper into the paper tray. Adjust the paper guide in the paper tray to the paper size. Remove the bent or creased paper, then load new paper into the paper tray. Remove damp paper, then load new dry paper into the paper tray. Load postcards or envelopes into the Manual Feed Tray. Correct the orientation of label sheets. Load envelopes so that flap parts are set on the lower left. Use our recommended paper. For information on the available paper, refer to Chapter 6 "Loading Paper" in [User's Guide Introduction]. Use the paper available with the Finisher. For information on the available paper, refer to Chapter 10 [User's Guide Introduction] in "User's Guide Introduction". Tips If a paper jam frequently occurs in a specific place, carry out checks, repairs, or cleaning focusing on the location of the jam. [Maintenance/Troubleshooting] 3-14