Kyocera KM-1650 Fax System (L) Operation Guide - Page 207
Error Code Tables, CAUSE AND/OR PROCEDURE FOR CORRECTION, Stop/Clear
View all Kyocera KM-1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
Reference Information Error Code Tables When a communications error occurs, one of the following error codes will be printed out on the corresponding Transmission Report or Reception Report as well as the Activity Report. Note If an error occurs during communication at a transmission speed of 33600 bps, the "U" in the error codes noted below will change to an "E". CODE Busy Stopped U00300 U00420 U00462 U00600 U00690 U00700 U00800 U00810 U00900 U00910 U01000 U01092 U01100 U01199 U01400 U01500 U01600 U01700 U01720 U01721 U01800 U01820 U01821 CAUSE AND/OR PROCEDURE FOR CORRECTION The line is busy or the other party does not answer after automatically redialling the set number of times. Perform transmission or reception procedures again. Transmission has been interrupted by pressing the Stop/Clear key. Reception has been interrupted by pressing the Stop/Clear key. During multiple communication (Polling Reception, etc.), this unit was unable to transmit to all destinations due to a communications interruption. The destination fax has run out of recording paper. Check with the destination party. Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted because the transmitting party does not possess the necessary communication capabilities. Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures again. Communication was interrupted due to trouble with the other party's fax unit. Check with the other party. Unsuccessfully transmitted page(s) remain. Perform transmission procedures again. Unsuccessfully received page(s) remain. Perform reception procedures again. A communication error occurred during transmission. Perform transmission procedures again. A communication error occurred during reception. Perform reception procedures again. A communication which uses the timer was scheduled, and a number was entered using an abbreviated number or one-touch key, etc., but communication with that party was impossible because that number was no longer registered when the scheduled time arrived. Check your unit. A communication error occurred during transmission at high transmission speed. Perform transmission procedures again. A communication error occurred during reception at high transmission speed. Perform reception procedures again after having the transmitting party lower the transmission speed. A communication error occurred during transmission at high transmission speed. Perform transmission procedures again. A communication error occurred during transmission at high transmission speed. The destination party's fax may not have the corresponding high speed reception capabilities. If the destination party's fax number was dialled using an abbreviated number or one-touch key, change the transmission speed registered for that number to a lower setting and perform transmission procedures again. A communication error occurred during reception at high transmission speed. Perform reception procedures again after having the transmitting party lower the transmission speed. A communication error occurred during reception at high transmission speed. Your unit may not have the corresponding high speed reception capabilities. Perform reception procedures again after having the transmitting party lower the transmission speed. 10-7