Kyocera KM-1650 Fax System (L) Operation Guide - Page 93
Enter, Stop/Clear, Alternate Display, Message, Procedure, key is held down during a communication - time for maintenance
View all Kyocera KM-1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Troubleshooting Message Memory Full. Call for Service. Time for maintenance. Communication Error. Continue TX. [Continue transmission.] Original is too long. [Original sheet is too long.] Procedure The memory has reached its capacity while scanning in documents. Press the Enter key and then select Yes if you want to transmit those documents that have already been completely scanned. If you want to completely cancel the transmission, press the S key or the T key to select No and then press the Enter key. • If you do not press the Enter key within a certain amount of time, the Auto Clear function will engage and all corresponding data will be erased from memory. • In order to transmit all of the documents after you have completely canceled the operation, try transmission procedure again after memory becomes available or after you create available space in memory. Maintenance by qualified service personnel is required. Contact your service representative, an authorized service center or the place of purchase. If C and a 3-digit number are displayed as well, inform the service personnel of the displayed number. Maintenance by qualified service personnel is required. Contact your service representative, an authorized service center or the place of purchase. An error has occurred during a fax transmission or fax reception. Check the error code - which indicates the origin of the error - on the corresponding Transmission Report (or Reception Report) that is printed out after the error. This message will appear in response to pressing the Stop/Clear key while the Alternate Display key is held down during a communication to multiple destinations, such as Broadcast Transmission or Polling Reception. • Press the S key or the T key to select Yes if you want to continue the current operation. However, the individual communication in progress at the time the Stop/Clear key was pressed will be canceled. • Press the S key or the T key to select No if you want to cancel the communication to all remaining destinations. You attempted to use the Document Processor to transmit a document that was over 63" [1600mm] in length. Press the Enter key to eject the documents remaining in the document processor. The operation panel will return to the initial mode settings. Page 3-20 5-20 5-63 10-7 - 2-3 4-3