Kyocera KM-3035 Printing System (U) Operation Guide (Functions Edition) - Page 56

4. Selecting the Printer Settings 4-12 Additional settings About the additional settings It is possible to perform additional settings for the 6 items shown in the following chart. For the most efficient use of the printer functions, select the various settings according to your printing needs. Item Available settings 1 Form Feed Time Out - 495 seconds Sets the amount of time the machine will wait for the "GO" button to be touched before it prints the next page automatically. 2 Resource Protect mode OFF, Permanent, Permanent/ Protects downloaded resource data such as fonts and Temporary macros and saves the PCL resource even if the emulation protocol is changed. Under the "Permanent" setting, temporary resource information will not be protected, but under the "Permanent/Temporary" setting, temporary resource information will be protected as well. 3 Auto Continue On/Off and Recovery Time 000 - 495 seconds You can select to have the error state released and printing continue after a designated recovery time (Auto Continue) in cases when either of the following messages is displayed. "Memory overflow" "Print overrun" The length of the recovery time can be changed as well. 4 Finishing Error Off, On If the error detection setting for duplex (staple) printing has been turned "On", and you attempt to print onto a paper size and paper type that cannot be used for duplex (staple) printing, the error message will be displayed and printing will stop. To print onto one-side (no staple) of the paper only when the error message is displayed, press the "GO" key. The default setting is "Off". 5 Service Maintenance menu This is the maintenance menu used by the service personnel. Print Status Page 6 Printer Reset Resets only the Printer Board without the need to turn off power to the machine. Printer Reset 7 Dump received data Data received by the printer is printed out in hex code for program and file debugging purposes. This hex-dump mode will be released automatically in the following situations. • Touch the "GO" key. • A form feed timeout occurs. Print HEX-DUMP Remarks If the printer doesn't receive a "endof-data" command from the computer even after receiving the last portion of data for that job, the last page will not be printed and will be saved temporarily. Once the pre-determined amount of wait time passes, that data will be automatically printed. If, however, you select "0" for this setting, the data will NOT be printed out automatically. 4-44