Kyocera KM-C3232E BF-710 Installation Guide

Kyocera KM-C3232E Manual

Get Kyocera KM-C3232E PDF manuals and user guides View all Kyocera KM-C3232E manuals
Add to My Manuals
Save this manual to your list of manuals

Kyocera KM-C3232E manual content summary:

  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 1
    INSTALLATION GUIDE FOR THE CENTER-FOLDING UNIT GUIDE D'INSTALLATION DE LA PLIEUSE GUÍA DE INSTALACIÓN PARA LA UNIDAD DE PLEGADO EINBAUANLEITUNG FÜR MITTENFALTEINHEIT GUIDA ALL'INSTALLAZIONE DELL'UNITÀ DI PIEGATURA CENTRALE BF-710
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 2
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 3
    2 H Viti con testa a croce S M4 × 8 11 I Etichetta 1 J Slitta coprimanopola 1 (K) will be used when the center-folding unit is installed on the full-color machine. (K) will not be used in monochrome machine. K Cover V 2 Be sure to remove any fixing tapes or cushioning material attached to the
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 4
    1 2 1 3 3 4 Procedure Before installing the center-folding unit, turn the MFP's main power switch off and unplug the power cable from the power supply. Install the document finisher, and then install the center-folding unit. Removing the cover. 1. Open the front cover of the document finisher. 2.
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 5
    7 8 6 5 5 Removing the back cover. 4. Remove the four screws (5) to remove the back cover (6) from the document finisher. 7 7 Removing the reinforcing plate. 5. Remove six screws (7) to remove the left reinforcing plate (8). Tilt the left reinforcing plate (8) to pull out upwards. Installing
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 6
    machine] 7. Steps 8 and 9 below will be required when the center-folding unit (A) is installed on the full-color machine. Removing the divided part. 8. Remove divided part (9) from the base where the document finisher is located. D Reassembling the covers. 9. Install cover V (K) onto each of
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 7
    Schieber (E) heraus und befestigen Sie ihn mit den beiden M4 × 8 Passstift-Verbundschrauben (H). Um die Schraube auf der Rückseite des Schiebers (E) ohne Problems festzuziehen, öffnen Sie die rechte Abdeckung des Dokument-Finishers und ziehen Sie die Schraube von der rechten Seite (11) des Dokument
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 8
    A 13 A A 13 J H 14 14 H E H 15 Installing the cover handle saddle. 14. Install cover handle saddle (J) on the front side of center-folding unit (A) with two M4 × 8 tap-tight S screws (H). Installing the center-folding unit. 15. Pull out sliders (E) till they stop. 16. Align pawl (13) of
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 9
    lifting center-folding unit releasing lever (16). Install the cover assembled in step 6 when the center-folding unit is installed into the full-color machine. 19. Use two M4 × 8 tap-tight S screws (H) to secure rear cover (C) and front cover (D). 20. Store center-folding unit (A) into the document
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 10
    F A B Installing the folding tray. 21. Fit the projection of folding tray (B) into the inside hole of center-folding unit (A). H Installing the douser. Before installing the douser (F), make sure that center-folding unit (A) is securely stored. 22. Insert douser (F) into the lower front left of
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 11
    the area where the label is adhered on the right cover of the document finisher with alcohol and adhere label (I) aligning with making-off line. [Checking staple position] 1. In the center-stapling mode, perform a test copy with the paper fed from the main tray. A test copy must be made for each
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 12
    > Distance from the center: within ±2 mm Ajustement de la position des agrafes 1. Entrer le mode d'entretien U246, sélectionner BOOKLET FOLDER (Dossier brochure) et effectuer l'ajustement pour chaque format d'échantillon de copie. Lorsque A4R ou LTR (8,5po. × 11po.) est utilisé, suivre STAPLE POS
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 13
    3mm 3mm 1 c 2 d 2 e [Checking centerfold position] 1. Plug the MFP into a power outlet, and turn on its main power switch. 2. Perform a test copy in centerfold mode. A test copy must be
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 14
    the setting value. Ajustement de la position de la page centrale dépliable 1. Entrer le mode d'entretien U246, sélectionner BOOKLET FOLDER (Dossier brochure) et effectuer l'ajustement pour chaque format d'échantillon de copie. Lorsque A4R ou LTR (8,5po. × 11po.) est utilisé, suivre BOOKLET POS ADJ1
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 15
    English NOTICE This accessory is for use only with the following Applicant's Listed Machine. Mode：l DF-710 Français AVIS Cet accessoire est utilisable uniquement avec le copieur figurant dans la liste du demandeur suivant. Modèle: DF-710 Español AVISO Este accesorio es sólo para usar en las
  • Kyocera KM-C3232E | BF-710 Installation Guide - Page 16
    2006. 2 303J156710 Rev1.0
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
INSTALLATION GUIDE FOR THE CENTER-FOLDING UNIT
GUIDE D’INSTALLATION DE LA PLIEUSE
GUÍA DE INSTALACIÓN PARA LA UNIDAD DE PLEGADO
EINBAUANLEITUNG FÜR MITTENFALTEINHEIT
GUIDA ALL’INSTALLAZIONE DELL’UNITÀ DI PIEGATURA CENTRALE
中折りユニット設置手順書
BF-710