LG 37LD320H User Manual - Page 235

Cloning Overview / Clonable Menu Features IMPORTANT CLONING INFORMATION There are three options for cloning a Master TV Setup: • Using a USB memory device • Using a TLL-1100A clone programmer • Using a LT2002 clone programmer Each option is described in further detail on the pages that follow. As you perform cloning procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicated does not appear, there is a problem with that step, and cloning may not be successful. Warning: Copying a blank or incorrect memory into a TV will cause the TV to operate erratically or become inoperable. Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs. Also, if the TV is in LodgeNet PPV Mode (check with the site administrator if you are not certain), do not connect a clone programmer to the GAME CONTROL/MPI port. Either of these actions will damage the clone programmer and, if applicable, the PPV card. Before you begin cloning: • Complete the Commercial Mode Setup for Master TV procedure on pages 12 to 13. • All equipment should be connected to power and turned ON. • Both the Master and Target TVs must be in Pass-through Mode. • Ensure Installer Menu items on Target TVs are set/restored to factory default settings (i.e., set Installer Menu item 117 FACT DEFAULT to 001 on Target TVs) before Teaching is initiated. • Learning and Teaching is only possible between identical model TVs. • If using a USB memory device, ensure the USB device has been formatted with FAT format. • For both Master and Target TVs-If using a clone programmer, ensure the TV signal source is either an Aux or TV (RF) source. If a TV (RF) source, the TV must be tuned to an analog (not a digital) channel. • LT2002 only-Make sure the batteries in the clone programmer are fresh. If batteries are removed, the clone programmer clock time (if set) will be lost (see page 28 for information on the clone programmer clock). • Do not unplug the TV power cord or remove/disconnect the USB memory device/clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction or harm the USB device/clone programmer, respectively. Clonable Menu Features Installer Menu Installer Menu item settings Channel Auto Tuning (Channel Lineup) Manual Tuning Channel Edit Channel Label Picture Aspect Ratio Picture Mode Advanced Control Audio Auto Volume Clear Voice Sound Mode Balance TV Speaker Option Menu Language Audio Language Caption Caption Mode Digital Caption Options Lock Movie Rating TV Rating - Children TV Rating - General Input Block Time Auto Clock Manual Clock Off Time On Time Auto Off (Sleep Timer) Note: Some menu options vary between analog and digital channels and Aux sources. 206-4186 23