LG FLATRON Service Manual - Page 18

(5) DVI *M198WA - Select input DVI model 112(1440*900@60hz), 64 Gray Scale pattern and whether picture is displayed or not *M208WA / M228WA - Select input DVI model 122(1680*1050@60hz), 64Gray pattern and whether picture is displayed or not. 4.7. DPM operation confirmation - Check if Power LED Color and Power Consumption operate as standard. (1) Set Input to RGB and connect D-sub cable to set. (2) Measurement Condition : 230V@ 50Hz (Analog) (3) Confirm DPM operation at the state of screen without Signal 4.8 DDC EDID Write 1) Connect D-sub Signal Cable to D-Sub Jack. 2) Connect HDMI Signal Cable to DVI Jack. 3) Write EDID DATA to EEPROM(24C02) by using DDC2B protocol. 4) Check whether written EDID data is correct or not. (refer to Product spec). (1) M198WA EDID DATA 1) ANALOG DATA 128Byte 2) DIGITAL DATA 256Byte (3) M228WA EDID DATA 1) ANALOG DATA 128Byte 2) DIGITAL DATA 256Byte 2) DIGITAL DATA 256Byte (2) M208WA EDID DATA 1) ANALOG DATA 128Byte 4.9. HDCP SETTING (High-Bandwidth Digital Contents Protection) 1) Connect D-sub Signal Cable to D-Sub Jack. 2) Input HDCP key with HDCP-key- in-program. 3) HDCP Key value is stored on EEPROM(AT24C64) which is E00~F20 addresses of 0xBC~0xBE page. ADH ADL LEN BC 00 128 BC 80 128 BE 00 33 4) AC off/ on and on HDCP button of MSPG925 and confirm whether picture is displayed or not of using MSPG925. 5) HDCP Key value is different among the sets. 4.10. Outgoing condition Configuration 1) After all function test., press IN-STOP Key by SVC Remote controller. And Make Ship Condition. 2) When pressing IN-STOP key by SVC remocon, Green and red LED are blinked alternatively. And then Automatically turn off. (Must not AC power OFF during blinking) - 18 -