LG LBC24360ST Service Manual - Page 44
Check
View all LG LBC24360ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
11-1 CHECK A - There is PC Board located in the PCB case. The control driver is PC board for the compressor. - This step shows the source voltage of the driver PC board. Step1. Open PCB Cover Step2. Check Driver PCB * Driver PCB located in back plate cover behind the refrigerator. LED Lamp IPM Output check - Measure the voltage between the POWER and COMM pins of the connector as shown below. Check to make sure compressor is receiving voltage from IPM Multi Tester A-Inverter - In order to determine whether the compressor is operating normally, check the output voltage during the refrigeration cycle. - After initial power-up, when the compressor begins to operate, wait 10 minutes before checking. - The compressor is operating normally if the voltage is greater than 80V. 44