LG LTG4715BD Owners Manual - Page 48
EasyClean, Start, CLEAR/OFF
View all LG LTG4715BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
48 MAINTENANCE 5 Spray or pour the remaining water (8 oz or 240 ml) onto the bottom center of the oven cavity. The indentation on the oven bottom should be fully covered to submerge all soils. Add water if necessary. NOTE If cleaning multiple ovens, use an entire bottle of water to clean each oven. Do not spray water directly on the door. Doing so will result in water dripping to the floor. 6 Close the oven door. Turn the oven mode knob to select EasyClean®. Press Start. CAUTION •• Some surfaces may be hot after the EasyClean® cycle. Wear rubber gloves while cleaning to prevent burns. •• During the EasyClean® cycle, the oven becomes hot enough to cause burns. Wait until the cycle is over before wiping the inside surface of the oven. Failure to do so may result in burns. •• Avoid leaning or resting on the oven door glass while cleaning the oven cavity. 7 A tone will sound at the end of the 10 minute (Lower) / 15 minute (Upper) cycle. Touch CLEAR/OFF to clear the display and end the tone. 8 After the cleaning cycle and during handcleaning, enough water should remain on the oven bottom to completely submerge all soils. Add water if necessary. Place a towel on the floor in front of the oven to capture any water that may spill out during hand-cleaning. If you are cleaning the upper oven on a double oven range, it is also best to cover the holes in the top of the lower oven door with a towel to capture any water that may drip into the door during hand cleaning. 9 Clean the oven cavity immediately after the EasyClean® cycle by scrubbing with a wet, non-scratch scouring sponge or pad. (The scouring side will not scratch the finish.) Some water may spill into the bottom vents while cleaning, but it will be captured in a pan under the oven cavity and will not hurt the burner. NOTE Do not use any steel scouring pads, abrasive pads or cleaners as these materials can permanently damage the oven surface. 10 Once the oven cavity is cleaned, wipe any excess water with a clean dry towel. Replace racks and any other accessories. 11 If some light soils remain, repeat the above steps, making sure to thoroughly soak the soiled areas. If stubborn soils remain after multiple EasyClean® cycles, run the Self Clean cycle. Be sure that the oven cavity is empty of oven racks and other accessories, and that the oven cavity surface is dry before running the Self Clean cycle. Consult the Self Clean section of your owner's manual for further details. If a self-clean option is not available, scrape off and remove stubborn soil using a scraper. NOTE •• If you forget to saturate the inside of the oven with water before starting EasyClean®, press CLEAR/OFF to end the cycle. Wait for the range to cool to room temperature and then spray or pour water into the oven and start another EasyClean® cycle. •• The cavity gasket may be wet when the EasyClean® cycle finishes. This is normal. Do not clean the gasket. •• If mineral deposits remain on the oven bottom after cleaning, use a cloth or sponge soaked in vinegar to remove them. •• It is normal for the fan to operate during the EasyClean® cycle.