LG WKEX200HWA Owners Manual - Page 23
Connecting the Drain Hose
View all LG WKEX200HWA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
ENGLISH 4 Flush out the inlet hoses. • After the hoses are connected, turn on the water faucets and flush out any foreign substances such as dirt, sand, or sawdust. • Let the water drain into a bucket, and check the water temperature to make sure you've connected the hoses to the correct faucets. 5 Attach the inlet hoses to the back of the appliance and secure the cold water inlet hoses with tie straps k. For the Washer • Attach the hot water inlet hose i to the hot water inlet on the back of the washer. Attach the cold water inlet hose j to the cold water inlet on the back of the washer. For the Dryer • Attach the cold water inlet hose j to the cold water inlet on the back of the dryer. • Tighten the fittings securely. Turn on both faucets all the way and check for leaks at both ends of the hoses. INSTALLATION 23 WARNING • The drain hose should always be properly secured. Failure to properly secure the drain hose can result in flooding and property damage. NOTE • The drain must be installed in accordance with any applicable local codes and regulations. • Make sure that the drain hose is not stretched, pinched, crushed, or kinked. • Do not install the drain hose with the end lower than 29.5 inches (75 cm) or higher than 96 inches (244 cm) above the bottom of the washer or more than 60 inches (152 cm) away from the washer. • Never create an airtight seal between the hose and the drain with tape or other means. If no air gap is present, water can be siphoned out of the drum resulting in poor wash/rinse performance or clothing damage. Using a Standpipe to Drain 1 Clip the end of the hose into the elbow bracket. • Connect the elbow bracket a within 4 inches (10 cm) of the end of the drain hose. If the drain hose is extended more than 4 inches (10 cm) beyond the end of the elbow bracket, mold or microorganisms could spread to the inside of the washer. 4 " (10 cm) 2 Insert the end of the drain hose into the standpipe. Connecting the Drain Hose Connect the drain hose to either a standpipe or laundry tub.