Lenovo ThinkPad X200s Hardware Maintenance Manual - Page 111
When installing, For ThinkPad X200, For ThinkPad X201 and X201i
View all Lenovo ThinkPad X200s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Table 24. Removal steps of system board, DC-in connector, fan, and ExpressCard slot assembly for ThinkPad X200, X201, and X201i (continued) When installing: • Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, on the part marked a as in the following figure. Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. You need to peel the thin film off from the rubber b . For ThinkPad X200: b a For ThinkPad X201 and X201i: b a • Make sure that the fan connector is attached firmly. Note: The ExpressCard slot assembly is attached to the system board. 1 Chapter 8. Removing and replacing a FRU 105
Table 24. Removal steps of system board, DC-in connector, fan, and ExpressCard slot assembly for ThinkPad X200,
X201, and X201i (continued)
When installing:
•
Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, on the
part marked
a
as in the following figure. Either too much or too less application of grease can cause a thermal
problem due to imperfect contact with a component. You need to peel the thin film off from the rubber
b
.
For ThinkPad X200:
a
b
For ThinkPad X201 and X201i:
b
a
•
Make sure that the fan connector is attached firmly.
Note:
The ExpressCard slot assembly is attached to the system board.
1
Chapter 8
.
Removing and replacing a FRU
105