Linksys SGE2000 Cisco RPS1000 380W Redundant Power Supply Administration Guide - Page 16
Site Requirements, Verifying the Package Contents
UPC - 745883572120
View all Linksys SGE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Chapter RPS1000-Business Series 380W RPS Unit Installation & Administration 3 Site Requirements Be sure to observe these requirements as you determine where to place the RPS1000: WARNING: This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security. For proper operation, where you locate the RPS1000 is extremely important. If the equipment is placed too close together, the ventilation is inadequate, and panels are inaccessible, malfunctions and shutdowns might result, and maintenance will be difficult. Consider this information when you plan the location of the chassis: • Provide for access to both the front and rear panels of the RPS1000. • Make sure that the room where the RPS1000 operates has adequate ventilation. Ambient air temperature might not cool equipment to acceptable operating temperatures without adequate ventilation. See the RPS1000-Business Series 380W RPS Quick Installation Guide for temperature requirements. Verifying the Package Contents NOTE: Carefully remove the contents from the shipping container and check each item for damage. If any item is missing or damaged, contact your Cisco representative or reseller for support. Replace all packing material into the shipping container and save it. These items are shipped: • The RPS1000 • This Linksys Business Series RPS1000 Redundant Power System Hardware Installation Guide • Product Registration Card • AC power cord • One 16-pin-to-14-pin DC connector cable • Mounting kit that contains: - Four rubber feet for mounting the switch on a table - Two mounting brackets - Four Phillips flat-head screws for attaching the brackets to the switch - Four Phillips truss-head screws for attaching the brackets to the switch Chapter 3: Installation 13 Preparing for Installation