Maytag MGD6300TQ Use and Care Guide - Page 12
i: c I;o}
View all Maytag MGD6300TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Make Gas Con i: c I; o}" 1. Remove the red cap from the gas pipe. 2. Using a wrench to tighten, connect the gas supply to the dryer. Use pipe-joint compound on the threads of all non-flared male fittings. If flexible metal tubing is used, be sure there are no kinks. A B... 1. Using a 4" (1 0.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Check that the vent is secured to exhaust hood with a 4" (1 0.2 cm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas modeis) Check that there are no kinks in the flexible gas line. 4. Once the exhaust vent connection is made, remove the corner posts and cardboard. A. fTared male thread B. Non-flared male thread NOTE: For I.P gas connections, you must use pipe-joint compound resistant to the action of I.P gas. I])o not use TEFI.ON _÷ tape. A combination of pipe fittings must be used to connect Shown is a recommended connection. Your connection supply line type, size and location. the dryer to the existing gas line. may be different, according to the Check the levelness of the dryer by first placing a level on the top of the dryer near the conso[e. ! Then, by placing a level in the crease on the side of the dryer between the top of the dryer and the dryer cabinet, check the levelness from front to back. A C B A. a_,,flexible gas connector B. a_,,ctryer pipe C. a_,,to a_,,pipe elbow D. a_,,pipe-to-flare adapter fitting 3. Open the shutoff valve in the supply line. The valve is open when the handle is parallel to the gas pipe. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or clown and check again for levelness. A. Closed valve B. Open valve 4° Test all connections by brushing on an approved noncorrosive Bubbles will show a leak. Correct any leak found. leak-detection solution. t-_JFEF[ ON is a registered trademark of E.I. Du Pont De Nemours and Company. 12