Maytag MGDE300VF Use and Care Guide - Page 12

Choose your exhaust installation type Recommended exhaust installations Typical installations vent the dryer from the rear of the dryer. Other installations are possible. B A B C A. Standard rear offset exhaust installation B. Left or right side exhaust installation C. Bottom exhaust installation Alternate installations for close clearances Venting systems come in many varieties. Select the type best for your installation. clearance installations are shown. Refer to the manufacturer's instructions. Two close- A. Dryer B. Elbow C. Waft D. Exhaust hood E.Clamps £ Rigid metal or flexible metal vent C. Vent length necessary to connect elbows H. Exhaust outlet Optional exhaust installations This dryer can be converted to exhaust out the right side, left side or through the bottom. If you prefer, you may contact your local dealer to have the dryer converted Fire Hazard Cover unused exhaust holes with one of the following kits: 279818 (white) W10186596 (midnight grey) Contact your local dealer, Failure to follow these instructions can result in death, fire, electrical shock, or serious injury, , ..... A "'i' ...... B A. Over-the-top insta//ation (also available with one offset elbow) B. Periscope insta//ation NOTE: The following kits for dose clearance alternate installations are available for purchase. Please see the "Assistance or Service" section to order. • Over-the-Top Installation: Part Number 4396028 • Periscope Installation (For use with dryer vent to wall vent mismatch): Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch Part Number 4396014 - 29" (73.66 cm) to 50" (127 cm) mismatch 12