Maytag MMV4205BAQ Installation Instructions - Page 19
Installation, Instructions, ATTACH, THE MOUNTING, PLATE, TO THE WALL, To use toggle, bolts, - parts
View all Maytag MMV4205BAQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation Instructions C2.__A..TTACH THE MOUNTING TO THE WALL (cont.) To use toggle bolts" PLATE Spacing for Toggles More Than Wall Thickness Mounting Plate I Toggle Wings C4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST 1, Remove and save screw that holds btower Plate to microwave. Blower motor screw. 2, Lift up the Blower Plate. Blower Motor Back of Microwave Belt End 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure to coincide bottom line of the Mounting plate with Horizontal line of "Rear wall Template" and then the Mounting plate is properly centered under the cabinet. CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4, Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. C3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. "_'_r..... Blower Motor Screw 3, Carefully putt out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. End B CAUTION: Do not touch blade of blower to prevent cracking and breaking. Hold outer case when the blower is removed and re-installed. 4, Remove "Parts "A" with Nipper or Scissors Knockouts Parts'A" 5. Rotate blower unit counterclockwise 180 °. Before Rotation After Rotation • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions TOP CABINET TEMPLATE. on the CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. 19 Back of Microwave Back of Microwave