Motorola WR850G User Manual - Page 54

Networking  Port Trigger, The Internet Control Message Protocol is - hosting games

Get Motorola WR850G - Wireless Broadband Router PDF manuals and user guides
UPC - 612572095027
View all Motorola WR850G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

CONFIGURATION SECTION 3 Field UDP Session Idle Time Description User Datagram Protocol. A method used along with the IP to send data in the form of message units (datagram) between network devices over a LAN or WAN. Used primarily for broadcasting messages over a network. The default is 8 hours. ICMP Session Idle Time The Internet Control Message Protocol is a protocol used for error, problem, and informational messages sent between IP hosts and gateways. The default is 5 minutes. Networking - Port Trigger When you run a PC application that accesses the Internet, it typically initiates communications with a computer on the Internet. In some applications, especially gaming, the computer on the Internet also initiates communications with your PC. Because NAT does not normally allow these incoming connections to occur, the BR700 supports port triggering. The BR700 is configured with port triggering for some common applications. You can also configure additional port triggers if needed. Configuring port triggers for an application requires a Port Trigger entry, explained below. SECTION 3, CONFIGURATION 3-23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
CONFIGURATION
SECTION 3
SECTION 3, CONFIGURATION
3-23
Field
Description
UDP Session Idle
Time
User Datagram Protocol. A method used along
with the IP to send data in the form of message
units (datagram) between network devices
over a LAN or WAN. Used primarily for
broadcasting messages over a network. The
default is 8 hours.
ICMP Session Idle
Time
The Internet Control Message Protocol is a
protocol used for error, problem, and
informational messages sent between IP hosts
and gateways. The default is 5 minutes.
Networking - Port Trigger
When you run a PC application that accesses the Internet, it typically
initiates communications with a computer on the Internet. In some
applications, especially gaming, the computer on the Internet also
initiates communications with your PC. Because NAT does not
normally allow these incoming connections to occur, the BR700
supports port triggering.
The BR700 is configured with port triggering for some common
applications. You can also configure additional port triggers if
needed. Configuring port triggers for an application requires a Port
Trigger entry, explained below.