NEC NEC-80570 User Guide - Page 28

Analog Door Box Door Box 1 80200 - 30 BLK BLUE GRN NC NC Door Box 1T Door Box 1R Relay 1T Relay 1R Door Box 1 Relay To DOOR1 in DS1000 cabinet YEL WHT RED Figure 4-2: Connecting an Analog Door Box Programming the Door Box Door Box Setup You must assign the chime pattern to each installed Door Box. q In 1801 - Door Chime, enter the Door Chime type. 0 = Normal Ring Group ringing. 1 = Low pitch chime pattern. 2 = Mid range pitch chime pattern. 3 = High pitch chime pattern. If you enter Door Chime type 0 (normal ring) above, you can set up Call Coverage keys for the Ring Group. This allows extensions that are not members of the Ring Group to answer Door Box calls. Extensions with Call Coverage keys to the Door Box Ring Group can also activate the relay (see Door Box Relay Control below). Door Box Ringing When a visitor at the door presses the Door Box call button, the Door Box will alert (chime) all the extensions in the Ring Group to which the Door Box belongs. For example, if the Door Box and extensions 301 and 302 are in Ring Group 1, pressing the call button alerts 301 and 302. q In 1802 - Ring Group Number, assign the Door Box and the extensions that should alert to the same Ring Group (1-8). q Ring Groups 1-8 are preset to use master numbers 600-607. Door Box Relay Control You normally set up Door Box 1 to control the Door 1 relays, and Door Box 2 to control the Door 2 relays (see 1801 - Relay Owner below). q In 0201 - Door 1 Relay, to assign the Door 1 Relay for door strike control, enter 1. q In 0201 - Door 2 Relay, to assign the Door 2 Relay for door strike control, enter 1. q In 1801 - Relay Owner, for the Door Box extension (324 or 325): - Enter 1 to have the Door Box control Door 1 relays. - Enter 2 to have the Door Box control Door 2 relays. 4-4 x Section 4: Optional Equipment DS1000 Hardware Manual